What Controls The Wait To Start Light

Wait To Start Light Assembly?

What Controls The Wait To Start Light. Web if you suspect a problem with the starting system (control box): Web 1.install the clamp on meter around the two output wires from the glow plug relay.

Wait To Start Light Assembly?
Wait To Start Light Assembly?

Web i have 98.5 and my wait to start light will not come on when you turn the key to the on position right away. I changed the selinoid last night and the light would come on for a couple on secounds and then go off. Wait until the light goes off before starting. Web illuminate if glow plug heat is necessary as a starting aid. When the ignition switch is. For most diesels, the light turns off when the glow plugs reach the established. It was cranking over but would not start so i had it towed home. Web then i turn the key back and wait 5 secs. It may be worth picking up a can of. Web the wait to start light wouldn't even blink.

Web then i turn the key back and wait 5 secs. 2.turn the key on and look for an initial reading of 160 amps or more. The light should always illuminate briefly, when the ignition key is in the on. When the ignition switch is. Check all 8 glow plugs. Web i have 98.5 and my wait to start light will not come on when you turn the key to the on position right away. Web the pcm controls the wts light and i would guess that your wiggling the fuses caused this fuse to make contact again. Wait until the light goes off before starting. Web the wait to start light wouldn't even blink. Web this message reminds you that the diesel engine may take a few minutes to start. Try it again, but this time i wait till after light goes out, then i watch to see voltmeter jump in positive direction and she starts.